Like your Z, this site is always underconstruction. :-)

Types of Kits

Full Body Kits are just that: They cover or replace all of the existing Z or ZX body, with the exception of the windshield and windshield frame.

If you are building a kit that requires removal of the roof of the car, reinforcing of the unibody chassis is recommended.

Fender Kits consist of the air dam, front fenders, rear quarters, and a rear spoiler. The Subtle Z kit includes the hood, which is available as an upgrade on both the 940Z  and 280YZ kits. The rear spoiler can be deleted from all kits for $150 credit.

The Subtle Z was designed primarily as a street kit, with the front fenders bolting on in place of the stock fenders. They can be attached with Dzuz fasteners for racing application. The Subtle Z is 1.5 inches wider than stock, on all four corners.

The 940Z  and 280YZ are designed as racing kits, with the front fenders having smaller returns and being designed to Dzuz on. However, they can be bolted on with slight modification. The 940Z kit is about 2 inches wider than stock on all four corners, while the 280YZ adds about 3 inches on either side at both front and rear.

Quality Note: The molds for the 940Z and the 280YZ kit are showing their age. Therefore, the parts will not be as pretty out of the box as those for the Subtle Z. The gelcoat will have a more "flat" appearance and there may be small imperfections. However, you can be assured that the quality of the lamination is top notch, and your parts will have as high a strength-to-weight ratio as any you can by for a comparable price. The steps required to mount, sand, prime, and paint these parts are exactly the same as if they were shiny! I will build new molds one of these days, but for the moment these parts are a good value and I will try to continue keeping the cost down.

All three fender kits utilize rear quarters that are designed to attach via either Dzuz fasteners or bonding over the existing rear quarters. The stock panels must be trimmed out to provide room for the larger wheels and tires required.

Any parts from these kits can be supplied separately. If you want to retain your stock front end, but need large rear quarters to cover monster drag slicks on your V8 Z, you can buy the rear quarters separately.

Conversely, if you have already modified your rears and want to upgrade the fronts, you can purchase separately any of our front fenders. Please note, however, that because of the extra width you will need to either purchase a matching air dam, or modify the one you are planning to use.

Installation of a fender kit is mostly bolt-on in the front. In the back, there are two ways to do it. Most racers remove most of the quarter panel (technically the "fender" is the front, the rear is part of the unibody and is called a "quarter panel") and attach with Dzus quarter-turn fasteners for easy removal and installation. Since it is part of the structure, most racers tie everything back together with tubes connected to the roll cage.

For street use most customers simply trim out the quarter panel to a profile that matches the size of the height of the wheel. So you make a cut at the lip edge of the quarter panel to separate it from the wheel well. Then cut out from the outer panel a crescent moon shape that peaks about 3 inches above the lip. The inner panel can then be slotted and the tabs bent up to be re-attached for structural integrity.

Roadster Kits consist of a header cap for the top of the windshield, a rear deck, and a trunk lid. We are not currently offering convertible tops for the kits because we are redesigning the previous tops. However, there is a removeable hardtop available for the Z Spyder.


USA check
Made in the USA for reduced ordering time and less expensive shipping.
Back to top